Garden table and chairs cover
one cover for the whole set
A garden table and chairs cover made to measure protects your table and the chairs around it with a single cover - round or rectangular, waterproof and ventilated by design. We sew every patio set cover, bistro set cover or garden dining set cover to your measurements in Cover-PVC, matched to the shape of the table and the height of the chair backs. That way the cover sits taut instead of flapping in the wind or collecting rainwater over the table top.
What sets this cover apart
A patio set is not a simple box: the chair backs form the high points, and the table top sits lower in between. An off-the-shelf table and chairs cover is usually cut too generously - the loose fabric sags over the table and rain collects there. That is why we sew our garden furniture set cover to the shape of your table, the footprint with the chairs pushed in and the height of the chair backs. Many patio table and chair covers are sold in a handful of standard sizes; ours is a one-off. Only need to cover the table? Then take a look at the garden table cover made to measure.
Round or rectangular
As a made to measure piece, we cut the cover to the shape of your set - round for a round bistro or dining table, or rectangular for a long dining table with chairs on every side.
No pool of water over the table
The cover lies over the chair backs with a defined tension. That leaves little loose fabric that could sag over the table top and form a hollow for water. Rain runs off over the sides.
Enough height for high-back chairs
Garden chairs with a high back need more height than a low lounge set. We set the height by your tallest chair back, so the cover reaches far enough down.
Secure hold in the wind
Tension straps with click buckles on the table or chair legs, plus a drawcord in the hem, keep the cover in place. We do not use elastic, which goes slack, or single eyelets, which tear out.
Fabric & properties
A good cover for a table and chairs has to keep rain out reliably and still be ventilated, so that no condensation forms underneath and wood, weave or metal do not suffer. We do not solve this with a "breathable" fabric but through the construction: we sew from Cover-PVC, a vapour-tight, PVC-coated polyester fabric with a 4,000 mm water column - so it really is waterproof. At least two concealed vents and a ground clearance of at least 5 cm let air circulate, so moisture escapes without letting rain in.
How to measure your patio set
Push the chairs in to the table the way the set will stand when covered, then always measure the whole set including the chairs, not just the table. Four details are all it takes - and if in doubt, we check your measurements with you before production.
Choose the table shape
Tell us whether your set is round or rectangular. The cut of the cover follows from that.
Diameter, or length and width
For round sets, measure the diameter from chair back to chair back across the table; for rectangular ones, length and width at the widest point - in each case including the chairs.
Height to the chair back
Measure from the ground to the top edge of the tallest chair back. The cover ends at least 5 cm above the ground, so air can flow in at the bottom.
Sketch or photo
For corner benches, armrests that reach over the table or other special features, simply upload a sketch or a photo of your set.
Matching covers
If your table and chairs do not always stand together, you can also cover them separately. For the rest of the garden we sew further covers made to measure.
Frequently Asked Questions
Sources
Last reviewed: 24.09.2026 · Reviewer: Germes-Team
Unsure about size or fabric?
Order a fabric sample or ask for advice - we check your measurements and find the right cover for your patio set, table and chairs together with you.